![G2H [Green2Heat] Webshop](https://shop.g2h.li/wp-content/uploads/2024/02/g2h-logo-46px-high.png){kind=logo}
ATTENTION! Experience shows that these relays have a higher failure rate, but so far they have not been in continuous operation right from the time of commissioning (Test phase so far approx. 1 year)! Robust semiconductor relay for direct current loads with load voltages between 1…100 volts DC, max. 100A (nominal current – note discounts). Input voltage 4-32VDC. With transparent contact protection cap to ensure compliance with the minimum protection class when used in control cabinet construction IP20. Switching status display via LED when the load is switched. PUK design. Fastening via two holes on a flat, heat-dissipating mounting plate.
Specifica tecnica
| Dimensioni | Dimensioni esterne ca. 60x48x34mm inclusa protezione contatti. |
| Tipo di circuito | Circuito a tiristori senza contatto per frequenze di commutazione elevate. Senza usura meccanica! |
| Commutazione di carichi | Carico nominale 100A. Nel calcolo del carico effettivamente collegato devono essere prese in considerazione le consuete detrazioni per SSR. |
| Intervallo di tensione in ingresso | 4-32V CC |
| Intervallo di tensione di carico | 1 …100 V CC |
| Classe di protezione | IP 20 |
| Assemblea | Su una superficie piana e dissipatrice di calore (piastra di montaggio per quadro elettrico) utilizzando due fori esistenti, diametro ca. 4,5 mm. Distanza tra i fori ca. 43mm, disposti centralmente. |
Application
When designing switching loads, the usual discount factors for SSR relays from the specified nominal load must be taken into account. So are e.g. B. for switching inductive loads (e.g. motors) when using SSR relays, often only 1/8 of the specified nominal load of the SSR has to be taken into account for operation with motors. For ohmic loads, the actual load can usually be up to 20% of the specified nominal load. With medium to high loads and ED >20% (ED = duty cycle), the use of a heat sink to dissipate thermal energy is necessary. As a preventive measure, we generally recommend the use of suitable heat sinks.
